Isis Enable/Disable IS-IS Unicast Routing Protocol (IS-IS) Interface-vlan Enable/Disable interface vlan Hsrp Enable/Disable Hot Standby Router Protocol (HSRP) Glbp Enable/Disable Gateway Load Balancing Protocol (GLBP) % invalid command detected at '^' marker.īgp Enable/Disable Border Gateway Protocol (BGP)Įigrp Enable/Disable Enhanced Interior Gateway Routing Protocol Pretty successful - just about all standard IOS commands used to configure layer-2 features work.įor this part of my rough test of the similarities between NX-OS and IOS, I attempted to configure the following:
Mark-Nexus01(config-if)# switchport trunk native vlan 2 Mark-Nexus01(config-if)# switchport trunk allowed vlan all Mark-Nexus01(config-if)# switchport mode trunk Mark-Nexus01(config)# interface ethernet 2/6 Have effect when the interface is in a non-trunking mode. %Portfast has been configured on Ethernet2/2 but will only Interface when portfast is enabled, can cause temporary bridging loops. Connecting hubs, concentrators, switches, bridges, etc. Warning: portfast should only be enabled on ports connected to a single Mark-Nexus01(config-if)# spanning-tree portfast Mark-Nexus01(config-if)# switchport access vlan 3 Mark-Nexus01(config-if)# switchport mode access Mark-Nexus01(config)# interface ethernet 2/2 Mark-Nexus01(config-vlan)# name anothertestvlan Next, I attempted to configure a number of basic layer-2 features using standard IOS commands:
#CISCO RIGHT TO USE LICENSE NEXUS 9000 SOFTWARE#
Some parts of this software are covered under the GNU Public Other third parties and are used and distributed under license. The copyrights to certain works contained herein are owned by Copyright (c) 2002-2008, Cisco Systems, Inc.
0 kommentar(er)
